
CY7C603xx
Document #: 38-16018 Rev. *D Page 13 of 29
Electrical Specifications
This section presents the DC and AC electrical specifications
of the enCoRe III LV device. For the most up to date electrical
specifications, confirm that you have the most recent data
sheet by going to the web at http://www.cypress.com
Specifications are valid for 0°C d T
A
d 70°C and T
J
d 85°C as
specified, except where noted.
Refer to Table 17 for the electrical specifications on the
internal main oscillator (IMO) using SLIMO mode.
Figure 6. Voltage versus CPU Frequency
Figure 7. IMO Frequency Trim Options
The allowable CPU operating region for 12 MHz has been
extended down to 2.7V from the original 3.0V design target.
The customer's application is responsible for monitoring
voltage and throttling back CPU speed in accordance with
Figure 6 when voltage approaches 2.7V. Refer to Table 15 for
LVD specifications. Note that the device does not support a
preset trip at 2.7V. To detect Vdd drop at 2.7V, an external
circuit or device such as the WirelessUSB LP - CYRF6936
must be employed; or if the design permits, the nearest LVD
trip value at 2.9V can be used.
Tab le 5 lists the units of measure that are used in this section.
3.60
V
3.00
V
93 kHz 12 MHz
CPU Frequency
Vdd Voltage
2.40
V
3 MHz
Valid
Operating
Region
2.70
V
3.00 V
93 kHz 12 MHz 24 MHz
IMO Frequency
Vdd Voltage
3.60 V
6 MHz
2.40 V
SLIMO
Mode=1
SLIMO
Mode=1
SLIMO
Mode=1
SLIMO
Mode=0
Table 5. Units of Measure
Symbol Unit of Measure Symbol Unit of Measure
°C degree Celsius PW microwatts
dB decibels mA milliampere
fF femtofarad ms millisecond
Hz hertz mV millivolts
KB 1024 bytes nA nanoampere
Kbit 1024 bits ns nanosecond
kHz kilohertz nV nanovolts
k: kilohm W ohm
MHz megahertz pA picoampere
M: megaohm pF picofarad
PA microampere pp peak-to-peak
PF microfarad ppm parts per million
PH microhenry ps picosecond
Ps microsecond sps samples per second
PV microvolts s sigma: one standard deviation
PVrms microvolts root-mean-square V volts
Kommentare zu diesen Handbüchern